电致变色技术
电子材料技术
 
目前位置:首页 科技信息   电子材料技术
 
Spin Coating

Spin coating is a procedure used to deposit uniform thin films to flat substrates. Usually a small amount of coating material is applied on the center of the substrate, which is either spinning at low speed or not spinning at all. The substrate is then rotated at high speed in order to spread the coating material by centrifugal force. A machine used for spin coating is called a spin coater, or simply spinner.

Rotation is continued while the fluid spins off the edges of the substrate, until the desired thickness of the film is achieved. The applied solvent is usually volatile, and simultaneously evaporates. So, the higher the angular speed of spinning, the thinner the film. The thickness of the film also depends on the viscosity and concentration of the solution and the solvent. A widely studied phenomenon in spin-coating is the coffee ring effect.

Spin coating is widely used in microfabrication of oxide layers using sol-gel precursors, where it can be used to create uniform thin films with nanoscale thicknesses.It is used intensively in photolithography, to deposit layers of photoresist about 1 micrometre thick. Photoresist is typically spun at 20 to 80 revolutions per second for 30 to 60 seconds.


更新时间:2016-7-3 20:49:31
 
Copyright@2010-2018  珠海凯为光电科技有限公司   粤ICP备10077888号-1   All Rights Reserved   http://www.zh-kv.com
地址:珠海市吉大园林路110号6楼    电话:+86 (0)756 3966815    传真:+86 (0)756 6210385    E-mail:info@zh-kv.com